Adsorption PO43- ion in aqueous solution using ZnO nanomaterials fabricated byelectrochemical method

Authors

  • Pham Huong Quynh Viện Công Nghệ - Trường Đại học Công Nghiệp Hà Nội
  • Luong Thi Anh Trường Đại học Công nghiệp, Đại học Thái Nguyên
  • Luu Thi Liu Trường Đại học Công nghiệp, Đại học Thái Nguyên
  • Ha Nam Phuong Trường Đại học Khoa Học, Đại học Thái Nguyên
  • Nguyen Phuong Chi Trường Đại học sư phạm, Đại học Thái Nguyên
  • Nguyen Thanh Trung Trung tâm Nghiên cứu và Phát triển Công nghệ Tiên Tiến, Hà Nội
  • Phung Thi Oanh Trung tâm Nghiên cứu và Phát triển Công nghệ Tiên Tiến, Hà Nội

DOI:

https://doi.org/10.51316/jca.2020.054

Keywords:

Adsorption, ZnO-nanomaterials, Phosphate ion, Electrochemical

Abstract

The study presents the results of the adsorption ability of phosphate ion (PO43-) in aqueous solution using ZnO nanomaterials fabricated by electrochemical method. The effects of initial pH (1-8), contact time (0-180 minutes), initial adsorbent dosages (0.2-1.2 g/L), and initial concentrations of PO43- ion (10-100 mg/L) have been studied at ambient temperatures (25°C±2°C). The results found the optimal conditions for adsorption of PO43- at pH=5, 90 minutes of equilibrium time, and 0.6 g/L of adsorbent dosages. The model of Langmuir has been found perfectly adequate to describe the equilibrium results of adsorption and the maximum capacity has been determined to be 101,01 mg/g. The results are promising for the use of ZnO nanomaterials to remove PO43- ion from the aqueous solution as well as the application of wastewater treatment in real conditions.

Downloads

Download data is not yet available.

References

S.-W. Bian, I.A. Mudunkotuwa, T. Rupasinghe, V.H. Grassian, Langmuir 27 (2011),p. 6059, https://doi.org/10.37628/jpnc.v4i2.757

M. Khodadadi, A.H. , L.R. , H.D. , N.N. , J Health Sci Technol 1 (2017),p.17. http://jhst.bums.ac.ir/article-1-29-en.pdf

B. Oram, Water research center (2014).https://www. water-research. net/index. php/phosphates)

M. Zarrabi, M.M. Soori, M. Noori Sepehr, A. Amrane, S. Borji, H.R. Ghaffari, Environmental Engineering and Management Journal (2014), p.891-903. http://eemj.eu/index.php/EEMJ/article/view/1866

M. Elkady, H. Shokry Hassan, E. Salama, Journal of Engineering, (2016) https://doi.org/10.1155/2016/2308560

D.T.H. Phuong, D. Van Thanh, N.P. Chi, N.X. Hoa, H.X. Linh, N.N. Huy, Journal of Electronic Materials 49 (2020) p.917, https://doi.org/10.1007/s11664-019-07749-8.

S. Tian, P. Jiang, P. Ning, Y. Su, Chemical Engineering Journal 151 (2009) p.141.,http://doi.org/10.1016/j.cẹ.2009.02.006.

V.Đ. Lợi, D.T. Hưng, N.T. Vân, Tạp chí phân tích Hóa, Lý và Sinh học 20 (2015),p.173, http://vci.vnu.edu.vn/upload/15022/pdf/576369037f8b9a71e78b45b1.pdf.

H. Liu, X. Sun, C. Yin, C. Hu, Journal of hazardous materials 151, (2008), p.616 https://doi.org/10.1016/j.jhazmat.2007.06.033.

B.V. Thắng, Nghiên cứu tổng hợp vạt liệu bentonit biến tính, ứng dụng hấp phụ phốtpho trong nước Báo cáo Tổng kết Đề tài Khoa học và Công nghệ Cấp Bộ , 2011.

Published

30-09-2020

Issue

Section

Full Articles

How to Cite

Adsorption PO43- ion in aqueous solution using ZnO nanomaterials fabricated byelectrochemical method. (2020). Vietnam Journal of Catalysis and Adsorption, 9(3), 82-87. https://doi.org/10.51316/jca.2020.054

Share

Most read articles by the same author(s)